D-Link DAS-3636 Cli Reference Manual page 189

create mld_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create MLD multicast VLAN mv1:
DAS-3626:admin#create mld_snoop multicast_vlan mv1 2
Command: create mld_snooping multicast_vlan mv1 2
Success.
DAS-3626:admin#
config mld_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
Restrictions
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to create an MLD multicast VLAN
create mld_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094>.
This command is used to create a MLD multicast_vlan. Multiple multicast VLANs can be
configured.
The MLD multicast VLAN being created can not exist in the 1Q VLAN database. Multiple
MLD multicast VLANs can be created. The MLD Multicast VLAN snooping function co-exists
with the 1Q VLAN snooping function.
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given a name
that can be up to 32 characters.
vlanid – The VLAN ID of the multicast VLAN to be create. The range is 2-4094.
Only Administrator and Operator-level users can issue this command.
Used to configure the parameter of the specific MLD multicast VLAN.
config mld_snooping multicast_vlan <vlan_name 32> {[add|delete] [member_port
<portlist>| tag_member_port <portlist> | source_port <portlist>] | state [enable |
disable] | replace_source_ip <ipv6addr>}
This command allows you to add member ports, add tag_member ports and add source ports
to the port list. The member port will automatically become the untagged member of the MLD
multicast VLAN, the tag_member_port and the source port will automatically become the
tagged member of the MLD multicast VLAN. To change the port-list, the new port-list will
replace the previous port-list if add or delete is not specified.
The member port list and source port list can not overlap. However, the member port of one
MLD multicast VLAN can overlap with another MLD multicast VLAN.
The MLD multicast VLAN must be created first before configuration.
<vlan_name> − The name of the VLAN to be created. Each multicast VLAN is given a name
that can be up to 32 characters.
Member_port – A range of member ports to add to the multicast VLAN. They will become the
untagged member port of the MLD multicast VLAN.
tag_member_port – Specifies the tagged member port of the MLD multicast VLAN.
source_port – A range of source ports to add to the multicast VLAN.
State – enable or disable multicast VLAN for the chosen VLAN.
replace_source_ip – With the MLD snooping function, the MLD report packet sent by the host
will be forwarded to the source port. Before the forwarding of the packet, the source IP
address in the join packet needs to be replaced by this IPv6 address.
Only Administrator and Operator-level users can issue this command.
184