Table of Contents
Advertisement
config vdsl line
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config vdsl .line use or no_use
DAS-3626:admin#config vdsl line 1 state no_use
config vdsl line 1 state no_use
Success.
DAS-3626:admin#
Example usage:
config vdsl line loopback test.
DAS-3626:admin#config vdsl line 4 loopback eoc times 3 size 64
Command: config vdsl line 4 loopback eoc times 3 size 64
[Loopback Test],mode=eoc,port=4,time=3,size=64
Test performed: 3, success: 3, fail:
Error Ratio : 0.0 %
Loopback Time Statistics (10 ms):
Max : <10 ms
Min : <10 ms
avr_time : <10 ms
Line 4 loopback test completed.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to configure vdsl line configuration
config vdsl line [<portlist>|all] [state [use(1)|no_use(0)]|name <name> | retrain | reset |
loopback [co_side(0)|eoc(1)|cpe_side(2)] times <int 1-400> size <int 64-1518> |
loop_diagnostic ]
This command will configure the VDSL line state,name,re-train,reset,loopback
test,loop_diagnostic
[<portlist>|all] – The list of port numbers to config
state− Used to use/no_use the VDSL line.
name −config vdsl line as assigned name.
retrain − re-train vdsl line .
reset − reset vdsl line .
loopback – Used to run loopback test
co side –Specifies that loop back test is internal .
eoc –Specifies that loop back test is external via VDSL EOC channel.
cpe side–Specifies that loop back test is external via VDSL DATA channel..
times – How many times to run loop back test.
size –Specifies pcket size
loop_diagnostic − run loop diagnostic on vdsl line.
Only Administrator-level users can issue this command.
0
415
Advertisement
Table of Contents
