Fiat 1996 Brava Service Manual page 866

Bravo-Brava
Bodywork
Interior trim
70.
REMOVING-REFITTING BONNET OPEN­
ING CABLE
1. Remove the upper cam cover protection.
2. Remove the trim shown in the figure by
undoing the retaining bolt and releasing
the diesel lines from the retaining clip.
3. Remove the bolt retaining the fuel line
connection bracket.
4. Disconnect connector of the brake and
clutch fluid level sensor, then remove the
stud retaining the lining of the bulkhead
between engine bay and cabin, then move
the trim to one side.
5. Unscrew the bolts fastening the diesel filter
bracket, disconnect connections shown
and place the bracket to one side.
Copyright Fiat Auto
13