Auto transmission and differential
Bravo-Brava ^
16v
Description and operation
21-27.
Stall speed test
This test serves to check the performance of the transmission and engine, and is conducted by measur
ing the maximum rpm that can be reached by the engine with the selector lever at position D and R.
E n
The duration of the stall speed test must not exceed 5 seconds.
P4A34AB01
To conduct the stall speed test, proceed as follows:
- chock the vehicle by placing wedges under the wheels;
- apply the handbrake fully;
- start the engine and bring it up to temperature;
- press the brake pedal down hard with the left foot;
- move the selector lever to position D;
- press the accelerator pedal down fully with the right foot and quickly read the maximum speed
reached by the engine.
Stall speed: 2300 ±150 rpm
Repeat the sequence of operations, but moving the selector lever to position R.
Stall speed: 2300 ±150 rpm
Stall speed
Lower than specified value in both
D and R
Higher than specified value in D
Higher than specified value in R
Higher than specified value in both
D and R
Possible causes
* Insufficient engine power
* Incorrect operation of free
wheel on stator of torque
converter
* Insufficient line pressure
* Clutch C1 and C3 slipping
* Incorrect operation of
free wheel F1
* Insufficient line pressure
* Clutch C2 slipping
* Clutch C3 slipping
* Brake B2 slipping
* Insufficient line pressure
* Clutch C3 slipping
34
Publication no.
506.670/06