Bravo-Brava ifii
16v
Auto transmission and differential
Servicing and adjustments
21-27.
Refitting
Refit the gear change cable and selector lever
by reversing the procedure for removal, bear
ing in mind the following:
- check that the gear change lever is posi
tioned at P (lever fully forward);
- check that the selector lever is also set to
position P;
fit the gear change cable head (1) to the
lever located on the gearbox. If the cable
length needs to be adjusted, adjust the
head (1) by screwing it or unscrewing it on
the threaded part of the cable, then lock it
with the nut (2). Finally fit the washer and
split pin;
operate the selector lever and check that, at
each position, you can hear the gear
change lever clicking into position.
Complete the assembly by securing the bat
tery cage, i.e. control unit, battery and air in
take duct.
Finally carry out the following checks:
- the engine must only start with the selector
lever in position P or N;
- each position of the selector lever must be
accompanied by the relevant indications on
the indicator panel and instrument panel
display.
Copyright Fiat Auto
45