Bravo-Brava ^
TD100
Engine
Removing - refitting cylinder head
10.
REFITTING AND TIGHTENING CYLIN
DER HEAD
1. Position the cylinder head on the engine
block, then tighten the retaining bolts to
torque. Ensure that the tightening order
shown in the figure is followed for each
tightening stage.
Oil screws and washers and leave to drain
for at least 30 minutes; screw in bolts to a
torque of 2 daNm, then carry out final
tightening to a torque of 6.5 daNm using
wrench 1852154000.
o ^ ^ ^ ^ / y
v ^
§m3l
f^^
^^(^RSr^/^^C*^
w
3. Tighten bolts through an angle of 270° in
three different stages (90°+90°+90°) us
ing wrench 1852154000 applied to tool
1860942000.
Copyright Fiat Auto
25