Fiat 1996 Brava Service Manual page 42

Introduction
Planned maintenance
Bravo-Brava
00.
H CHECK/ADJUST HANDBRAKE LEVER
TRAVEL
Operate the handbrake lever several times
and check that the travel of the toothed sec­
tor is 5 notches.
If this is not the case, proceed with the ad­
justment as follows:
- remove the protective boot for the control
lever;
- act on the adjustment nut shown, tighten­
ing or loosening it in order to increase or
decrease the handbrake lever cable travel;
- check that the lever travel is equal to 5
notches on the toothed sector.
When the adjustment has been car­
ried out, the control lever travel
should not exceed 5 notches on the
toothed sector.
With the handbrake lever In the rest
posit/on the rear wheels should rotate
freely; If this Is not the case, repeat
the adjustment.
m m CHECK/ADJUST TAPPET CLEAR-
■ " ANCE
The following components must be removed
in order to check and, if necessary, adjust the
tappet clearance.
Bravo-Brava 1910 TD
1. Remove the upper engine protection.
8
Print no. 506.670/09