Fiat 1996 Brava Service Manual page 57

Bravo-Brava
Introduction
Planned maintenance
oo.
Remove tool 1860899000 and refit the
2nd cap.
In order to carry out this operation it is
necessary to remove the bolts fixing the
1 st - 2nd - 3rd and 4th caps, exhaust side,
loosen the inlet ones, slightly raise the lu­
brication duct, remove the tool and posi­
tion the cap, tightening the cap fixing
bolts to the recommended torque.
Work with due care when raising the
lubrication duct to avoid the duct
from being distorted or broken.
Remove tool 1860901000 placed previ­
ously on the timing gear and rotate the
crankshaft through two revolutions in its
direction of rotation. Loosen the tension-
er fixing nut, make sure that the moving
index (1) coincides with the fixed refer­
ence (2), then lock the nut fixing the ten-
sioner and tighten it to the recommended
torque.
Refit the previously removed components,
taking care to refit the auxiliary shaft drive
pulley with the opening in the actual pul­
ley engaged with the dowel (1) on the
crankshaft pinion and also checking the
engine timing ensuring that the reference
(2) on the pulley corresponds with the
reference (3) on the timing belt shield.
Copyright by Fiat Auto
23