Electrical equipment
Control units
Bravo-Btava
9 8 r a n g e
55.
REMOVING-REFITTING J U N C T I O N U N I T
A N D SHIELD
Removing control unit shield
1. Undo the bolts (A) using the ignition key
or a suitable screwdriver; exert slight pres
sure on the left side of the shield in the d i
rection shown by the arrows to facilitate
the release of the t w o side retaining tabs,
then remove the shield.
2. After having removed the shield, discon
nect the connectors from the front of the
control unit and undo the bolts fixing the
control unit to the dashboard. Move the
control unit aside, disconnect the connec
tors from the rear and remove the control
unit from the dashboard.
Suitably reverse the operations car
ried out for the removal
Refitting control unit shield
3. Position the shield in the housing in the
dashboard, inserting the centering tabs lo
cated on the lower part.
4. Turn the shield upwards, until it is contact
with the dashboard.
Complete the refitting, proceeding as follows
(see figure 1):
- position the t w o bolts (A) in their housings
and tighten them by several turns;
- taking great care, exert slight pressure on
the left side of the shield (at both the side
and the front) so that the t w o side retaining
tabs are fully inserted in the dashboard;
- tighten the bolts (A).
P4A16HL04
16
XI-98 - Update
Print no.
506.670/17