Engine
Fuel system
Bravo-Brava ^
TD7S
10.
1. Remove the trim shown in the figure by
undoing the retaining bolts and releasing
the diesel lines from the retaining clip.
2. Remove the bolt retaining the bracket
joining the fuel lines.
3. Disconnect the connector of the brake and
clutch fluid level sensor, then remove the
stud retaining the lining of the bulkhead be
tween engine bay and cabin, and move the
lining to one side.
4.
5.
Unscrew the bolts retaining the diesel filter
bracket, disconnect the connections shown
and position the bracket to one side.
Move the lining of the bulkhead between
engine bay and cabin further to one side,
then unscrew the nut retaining the accele
rator cable to the bulkhead, remove the
underlying rubber guide and withdraw the
accelerator cable.
P4A06DA04
6
Publication no. 506.876