Clutch
Clutch operation
Bravo-Brava $
12v
18.
NOTE
Proceed as described for the left hand
drive version to remove the reverse in
hibitor, Note, however, that the bolt re
taining the inhibitor also secures the
clutch slave cylinder; remove the latter
without disconnecting the fittings. It will
now be possible to disconnect the re
verse inhibitor as shown in the figure.
1
ti
£=?
Mt
jLid
v3kll
S S
""T§§P--"-'
/
;*?
i j 8
--^___
x^%
SSL
w
7
JTjfj y
/ / ^ >
'O'/
^
P4A16DA02
BLEEDING
Connect the end of a hose to the clutch slave
cylinder bleed screw and insert the opposite
end in a suitable container. Fill the brake and
clutch fluid reservoir, then bleed the clutch
system by loosening the bleed screw on the
slave cylinder. Simultaneously press d o w n
the clutch pedal and allow it to return slowly.
Repeat the operation until all air bubbles
have been removed. With the clutch pedal
pressed to the floor, tighten the bleed screw
and remove the pipe.
During the bleeding operation, keep the fluid level in the tank above the MlN mark. Do not reuse
fluid drained during the disassembly and bleed stages.
Top up the fluid level in the reservoir and refit the cap. Lastly, check the efficiency of the hydraulic clutch
system.
8
Publication no. 508.876