Engine
Fuel system
Bravo-Brava ^
12v
10.
P4A02DA01
1. Remove the stud shown in the figure and
move the lining of the bulkhead between
engine bay and passenger compartment
to one side.
2. Unscrew the bolt retaining the accelerator
cable ducting device, on the bulkhead be
tween engine bay and passenger com
partment. Also remove the underlying
rubber block in order to free the hole and
allow removal of the cable.
3. Release the accelerator cable from the re
taining clip located beneath the injection
control unit.
4. Withdraw the cable through the hole in
the bulkhead between engine bay and
passenger compartment and remove from
the engine bay.
When refitting, adjust the cable as
described in the paragraph "Adjust
ing throttle cable"in Section 10 "Fuel
system" for the left hand drive ver
sion.
P4A02DA04
2
Publication no. 508.876