Fiat 1996 Brava Service Manual page 785

Electrical equipment
Service control unit
Bravo- Brava
98 range
55.
EOS
1. Red LED on remote control unit
2. Password code, 4-figure
3. Control button on sender unit
4. Green LED on courtesy light
5. Programming button
1. Green led
2. Store button
Receiver connector
1. Not connected
2. Provision for alarm system
3. Positive from battery (+30)
4. Earth
5. Door release
6. Door lock
7. Ingition-operated positive ( + 15)
8. Not connected
SIMPLIFIED P R O G R A M M I N G
A remote control unit must always be
stored with the ignition key remove or in STOP
or PARK position
With this programming system, any number of
remote control codes are recognised but only the
last 8 remain stored by the alarm system as fol­
lows:
1. press and hold down button (5) on the re­
ceiver built into the courtesy lightl. The adja­
cent LED (4) should flash.
2. Hold button (5) down and press remote
control unit key (3).
3. Then release key (3) when the light of led
(4) on the receiver should become fixed.
4. Then release button (5) on the courtesy light
at the end of the cycle.
5. The remote conrol unit is now programmed.
NOTE Repeat the operations below to store the
next remote control units.
6. If the receiver led stops flashing and goes off
(when the remote control ke is pressed), the
receiver memory is closed. Use PROTECTED
PROGRAMMING to store the remote control
unit code.
PROTECTED P R O G R A M M I N G
If the memory is closed, further remote control codes can be entered onlly after opening the memory.
OPENING M E M O R Y A N D STORING A N E W REMOTE CONTROL UNIT
Opening the memory
To open the memory, carry out the following operations in rapid succession:
1. Press button (5) on the receiver for about 1 second. LED (4) flashes as long as the button is pressed.
2. Release the button; after about 3 seconds, the LED emits a short flash to indicate that the first figure
of the password can be entered.
86 Publication no. 506.670/20