Engine
Replacing auxiliary belt
Bravo-Brava ^
TD100
10.
- Take great care not to damage individual components when the power unit is fitted
- When fitting the coo/ant lines, align groove on rubber hose with ridge on associated rigid
sleeve. When filling the cooling system, refer to section on "Removing-refitting radiator".
fjV^
Ensure that the power unit mounting points are properly secured.
Clutch pedal height.
REMOVING - REFITTING ALTERNATOR
DRIVE BELT AND POWER STEERING
PUMP
Removing
Position the vehicle on a lift, remove the right
front wheel, disconnect the battery negative
terminal and then proceed as follows.
1. Remove the wheel arch guard by un
screwing the retaining bolts shown. Use
tool 1870077000 to prise up the stud
shown.
Turn the tensioning device in the arrowed
direction and release belt tension before
removing.
Check the condition of the drive belt.
In particular, check for cracks, tears,
surface wear (smooth or shiny in ap
pearance) and dry or hard parts with
consequent loss of grip. Rep/ace belt
if even one of the above defects is
present.
12
Publication no. 506.670/08