Engine
Fuel system
Bravo- Brava 9 *»
'98 range
ENGINE CONTROL UNIT
Removing - refitting
Remove the control unit as follows:
- disconnect both connectors in two stages:
A) turn the metal hook up to release the
connection;
B) pull away the connection;
- unscrew the control unit retaining bolts and
remove.
Proceed as follows to refit the connector:
- move the connector into contact with the
control unit;
- turn the metal hook until completely closed.
NOTE If the engine control unit is replaced,
connect a tester (EXAMINER)
to the
tester connection and and run the self-
learning procedure for engine idle ad
justment actuator (M.D.S) data as de
scribed
in
the
"THROTTLE
BODY"
paragraph.
LAMBDA SENSOR
Removing - refitting
Disconnect electrical connection (1) and re
move sensor (2) from its seat on the exhaust
manifold.
When refitting, spread the threading with lubri
cant grease resistant to high temperature.
Engine R P M and TDC sensor
Removing-refitting
Disconnect the electrical connection.
Unscrew the retaining bolt and remove the
sensor.
Check the gap
Check the distance between sensor and phonic
wheel teeth (gap).
Gap: 0.5 - 1.5 mm
NOTE Whenever the sensor mount is serviced
(e.g. gap not as specified, sensor not
aligned etc.), the sensor must be cor
rectly positioned
and aligned with its
mount
as described
in
the
engine
service manual.
54
V-99- Supersedes previous version
Publication no. 506. 670/20