Fiat 1996 Brava Service Manual page 473

Bravo-Brava 101
'98 range
16v
Engine
Fuel system
10.
- disconnect the fuel delivery pipe from the quick-fit connector located against the rear wall of the en­
gine compartment and, using the connectors of the test equipment 1860955000, make the connec­
tions to the Flowtronic device (1806149001) as follows:
1. Cut and withdraw the end (A) of the connector (2), then connect the end (B) to the connector of
the rigid pipe (3) and the end (A) to the inlet pipe into the Flowtronic (4).
2. Insert the connector (5) into a piece of pipe (6) and lock it with a metal clip, then connect the end
(A) to the pipe (1) previously disconnected and the end (B) to the outlet pipe from the Flowtronic
device (4).
- carry out a fuel consumption road test in accordance with the Directive 93/116/CE (litres x 100 km):
URBAN CYCLE - includes one cold start, followed by a simulated varied urban journey.
OUT-OF-TOWN CYCLE - includes frequent accelerations, in all gears, simulating normal out-of-
town use of the vehicle; the speed varies between 0 and 120 km/h.
AVERAGE COMBINED CONSUMPTION - includes 37% urban cycle and 63% out-of-town cycle.
NOTE The type of journey, traffic situations, style of driving, weather conditions, level of fittings/ex­
tras/accessories, presence of roof rack, presence of special equipment and the general condi­
tion of the vehicle can lead to different fuel consumption values from those measured by the
above-mentioned procedures.
- check that the values measured correspond to those given in the "Introduction and technical data"
section.
Copyright Fiat Auto 61