Fiat 1996 Brava Service Manual page 62

Introduction
Planned maintenance
Bravo-Btava
00.
1
(s\
^^fe"®
^vvBb
^4y
/
VDL
(7)- f h /
J®
^®
^(2)
Tensionamento cinghia distribuzione
1. Complete the fitting of the belt in the fol­
lowing order: 1. Crankshaft gear (already
fitted) - 2. Oil pump gear - 3. Fixed pulley
- 4. Timing pulley, inlet side - 5. Timing
pulley, exhaust side -
6. Automatic tensioner.
Fit the belt with the camshaft pullies
facing towards the right in order to re­
cover any necessary clearance for fit­
ting the belt perfectly on the actual pul­
lies, ensuring the correct tension in the
section of the belt already fitted.
Remove the bolt (1) to allow tool
1860876000 for tensioning the timing
belt to be positioned.
Acting on tool 1860876000, place the
belt tensioner in the maximum tension po­
sition, then lock the tensioner nut. Re­
move the dial gauge and tighten the
camshaft pullies to a torque of 11.5 daNm
using tool 1860885000 on support
1860831001.
Remove tools 1860874000; rotate the
crankshaft through two revolutions in the
direction of rotation, loosen the nut locking
the tensioner and, using a special spanner
on the belt tensioner, position reference
(1) in line with reference (2), then tighten
the belt tensioner lock nut to a torque of
2.3 daNm.
As a further check, refit the dial gauge, de­
tect T.D.C. and check that tools
1860874000 fit on the camshafts, then re­
fit the components removed previously.
28
Print no. 506.670/09