Fiat 1996 Brava Service Manual page 570

Braking system Bravo-Brava
Active sensors 98 range
33l
The recommended distance (gap), to obtain the correct signals, between the end of the sensor and the
multi-polar ring should be between:
0.16 - 1.71 m m f o r t h e f r o n t w h e e l s
0.37 - 1.13 m m f o r t h e rear w h e e l s
This distance cannot be adjusted therefore if the gap measured is outside of the tolerance, check the
condition of the sensor and the multi-polar ring.
NOTE Each time an rpm sensor is fitted, it should be lubricated with water-repellant grease, to avoid
the effects of heat variations, over a period of time, causing deterioration and making it difficult
to extract.
Positioning of f r o n t w h e e l sensor
Positioning of rear w h e e l sensor
8
Print no. 506.670/17