Fiat 1996 Brava Service Manual page 823

Braking system
Hydraulic operation
Bravo-Brava
33.
P4A30DA03
1. Separate the brake servo from the pedal unit
by releasing the brake servo rod from the
transmission on the control pedal.
Refitting
2. Reverse removal instructions to refit. Take
care to position the control rod and wash­
er in their correct place on the brake servo,
to ensure that they do not come out of
place when fitting the brake pump.
REMOVIIMG-REFITTING PEDAL UNIT
Proceed as described for the brake
servo removal to remove the pedal
unit. Note that the brake pump need
not be removed from the brake servo
and vacuum intake pipe. Before re­
moving the pedal assembly, unscrew
the nuts retaining the brake servo to
the pedal mount as shown in the fig­
ure.
3. Unscrew nuts retaining the brake servo to
the pedal mount and remove the roll pin
securing the brake servo rod to the brake
pedal transmission.
4. Undo nuts securing the pedal mount and
remove from the car after releasing the
brake servo rod from the transmission on
the control pedal.
10 Publication no. 508.876