Bravo- Brava |p
1998 range
JTD
Engine
Fuel system
10.
Refitting
Reverse procedure described for removal to
the point where the pressure pump is refitted.
Then refit and tension the timing belt and
auxiliary drivebelt.
Check that the timing belt and auxiliary drive-
belt do not show signs of cracking or wear
that could impair operation.
Tighten thefittings of the pipes carrying fuel
from the pressure pump to the rail to a torque
of 2 daNm
Fitting and tensioning timing drive belt
1.
Fit the timing belt to the crankshaft gear
provisionally and remove the bolt indi
cated from the oil pump.
Position tool 1860905000 on the crank
shaft drive gear and pin (3); turn the
crankshaft through small movements until
locating dowel (2) fits into hole (4) on
the tool. In this position, cylinder no. 1 is
exactly aligned with TDC.
Secure the tool to the crankshaft drive
gear using the bolt shown.
Copyright Fiat Auto
41