Fiat 1996 Brava Service Manual page 794

Bravo-Brava @i
12v
Engine
Fuel system
10.
REMOVING-REFITTING
PEDAL
Disconnect the battery
then proceed as follows:
ACCELERATOR
negative terminal,
1. In the engine bay, turn the throttle valve
lever and release the accelerator cable. Re­
move the clip and withdraw the cable from
the bracket. This operation is necessary to
facilitate removal of the accelator cable
from the control pedal.
2. Working from inside the car, remove the
left foot rest by undoing the retaining
bolts shown in the figure.
3. Disconnect the control cable from the an­
chorage on the accelerator pedal.
4. Disconnect the clutch pedal reaction
spring (attached to the accelerator pedal
bracket) by removing the roll pin indicat­
ed.
P4A03DA02
Copyright Fiat Auto
3