Fiat 1996 Brava Service Manual page 297

Bravo-Brava @ 16v
98 range
Engine
Fuel system
10.
Removing the test equipment
Remove the test equipment 1860955000 with the key in the OFF position, following these instructions:
- introduce the end of the pipe connected to the valve (c) into a suitable container;
- open the valve (c) and drain the excess fuel into the container;
- keep the pipe in the container and disconnect the end of the supply pipe from the female connector for
the adaptor (A) keeping the connection upwards;
- let the fuel in the pipes flow into the container;
- disconnect the end of the adaptor (B) from the rapid connector and let the residual fuel flow from the
pipes into the container;
- reconnect the fuel supply pipe.
H
<
i
r
v
A
P
^ ^
^ \
Checking fuel consumption using
FLOWTRONIC equipment 1866149001
To carry out the check, the equipment should
be configured with the connectors shown in
the diagrams:
A. supply pipe side
B. fuel manifold side
If this has not been done, make the adjust­
ment following the instructions given below:
- cut the end of the FLOWTRONIC equip­
ment inlet pipe and replace it with a female
rapid connector (1), contained in the Kit
No. 1860955003, as illustrated in figure A;
B
<I>
cut the end of the FLOWTRONIC equip­
ment outlet pipe and replace it with a male
connector (2), contained in the Kit No.
1860955003, as illustrated in figure B.
The connectors removed should be
recovered and kept for any future
connections.
46
Print no. 506.670/76