Fiat 1996 Brava Service Manual page 41

Bravo-Btava
Introduction
Planned maintenance
oo.
P4A07CA01
n CHECK, ADJUST CLUTCH PEDAL
" TRAVEL OR HEIGHT
The check should only be carried out on ve­
hicles with mechanical release devices (1370
12v -1581 16v -1747 1 6v - 1910 TD - 1929
D). The 1998 20v engine type has a hydraulic
release device.
1. Measure the clutch pedal travel:
1. Pedal in end of travel position
2. Pedal in rest position
X. Pedal travel:
155 ± 10 mm (1370 12v)
170 ± 10 mm (1581 16v - 1747 16v -
1910 TD - 1929 D)
2. In order to adjust the clutch pedal in the
rest position it is necessary:
- to let the clutch operating mechanism
bed in by fully depressing the pedal 2 or
3 times;
- to check that the travel "X" corresponds
to the recommended figure. The travel
is measured using a rule corresponding
to the pedal centre line and is equivalent
to the distance between the pedal in the
end of travel position (pedal in contact
with the bodyshell) and the pedal in the
rest position.
- any adjustments to the travel are carried
out via the nut and lock nut for the
clutch cable, gearbox side.
NOTE There should be no obstructions in
the area under the pedals preventing
the total travel of the pedals: take
care, in particular, that any mats are
lying flat and not interfering with the
pedals.
Copyright by Fiat Auto 7