Fiat 1996 Brava Service Manual page 298

Btavo-Brava^tiev Engine
98 range Fuel system
10.
- discharge the fuel pressure inside the supply pipe and disconnect the pipe from the rapid connector,
following the instructions in the previous paragraphs;
- attach the end of the supply pipe to the female rapid connector for the FLOWTRONIC equipment and
the male connector to the rapid connector;
- position the equipment in the engine compartment, place the connecting electrical cable inside the
vehicle and connect the actual equipment as described in the instructions which come with the
equipment;
- proceed with the fuel consumption test in accordance with regulation 93/116 CE and check that the
figures correspond with those given in section 00 - Technical data.
1. Complete electric fuel pump 4. FLOWTRONIC equipment
2. Fuel supply pipe 5. Rapid connector
3. Female rapid connector 6. Fuel manifold
- carry out the fuel consumption road test in accordance with directive 93/116 CE (litres per 100 km):
URBAN CYCLE - this includes a cold start, followed by a simulated urban journey;
EXTRA-URBAN CYCLE - this includes frequent acceleration, in all the gears, simulating normal out of
town usage; the speed varies between 0 and 120 kph;
AVERAGE COMBINED CONSUMPTION - this involves 33% of the urban cycle and 67% of the ex­
tra-urban cycle;
check that the figures measured correspond to those in the section "Introduction and technical data".
NOTE Traffic conditions, driving styles, atmospheric conditions, trim levels / accessories, whether a
roof rack is fitted, the presence of special equipment and the general state of the vehicle, can
lead to fuel consumption figures which differ from those obtained using the procedures de­
scribed above.
Copyright by Fiat Auto 47