Assembling The Propeller Shaft Housing - SELVA MARINE Wahoo 15 Service Manual

LOWR
Assembling the propeller shaft
housing
1. Install a new needle bearing into the pro-
peller shaft housing.
NOTE:
Install the needle bearing with the manufac-
ture identification mark facing toward the oil
seal (propeller side).
Driver rod L3 1: 90890-06652
Needle bearing attachment 2:
90890-06616
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth a.
1
a
3
6-9
Lower unit
1
G
2
S6AG6160
A A
S6AG6170
NOTE:
6 Install an oil seal halfway into the propeller
shaft housing, and then install the other oil
seal.
Driver rod L3 1: 90890-06652
Needle bearing attachment 3:
90890-06613
Installation depth a:
3.0–3.5 mm (0.12–0.14 in)
3. Install a new ball bearing into the propel-
ler shaft housing.
NOTE:
Install the ball bearing with the manufacture
identification mark facing toward the reverse
gear.
Driver rod LS 4: 90890-06606
Ball bearing attachment 5:
90890-06632
4. Install the reverse gear and original
shim(s) into the propeller shaft housing.
4
5
G
S6AG6180
6AG3J11