Assembling The Propeller Shaft Housing - SELVA MARINE Grey Whale 200 EFI Service Manual

NOTE:
Install the dog clutch 4 with the "F" mark a
facing toward the shift rod joint 3.
Assembling the propeller shaft
housing
1. Install the needle bearing into the propel-
ler shaft housing to the specified depth.
NOTE:
• Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special service tool in a manner that will
force the stopper c out of place.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3: 90890-06603
Depth b:
25.3 ± 0.25 mm (1.00 ± 0.01 in)
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth.
6AL3J11
Propeller shaft housing (regular rotation model)
NOTE:
Install an oil seal halfway into the propeller
shaft housing, and then install the other oil
seal.
Bearing inner race attachment 4:
90890-06640
Depth d:
5.0 ± 0.25 mm (0.20 ± 0.01 in)
3. Install a new ball bearing into the propel-
ler shaft housing.
CAUTION:
Do not reuse the bearing, always replace
it with a new one.
NOTE:
Install the ball bearing with the manufacture
identification mark facing toward the propeller
shaft housing (propeller side).
Driver rod LS 5: 90890-06606
Ball bearing attachment 6:
90890-06656
1
2
3
4
5
6
7
8
9
6-10