Removing The Timing Belt And Sprocket - SELVA MARINE Wahoo 15 Service Manual

Removing the timing belt and
sprocket
1. Remove the flywheel magnet and stator
coil assembly.
NOTE:
See "Replacing the timing belt" (5-3).
" mark a on the driven
2. Align the "1
sprocket 1 with the " " mark b on the
cylinder head.
c
NOTE:
Check that the mark c on the drive sprocket
and the mark d on the cylinder block are
aligned.
3. Remove the timing belt 2 from the
driven sprocket, and then remove it from
the drive sprocket.
6AG3J11
5
1
a
b
S6AG5H80
d
S6AG5B25
Timing belt and sprocket
2
CAUTION:
Unless directed to do so in the following
instructions, do not
sprocket or driven sprocket when the tim-
ing belt is not installed. Otherwise the pis-
tons and valves will collide with each
other and be damaged.
4. Align the mark e on the drive sprocket
with the mating surface f of the crank-
case and cylinder block by turning the
crankshaft clockwise approximately 90°
gradually.
CAUTION:
Do not turn the crankshaft more than 90°.
Otherwise the piston and valves will col-
lide with each other and be damaged.
1
2
S6AG5H90
3
turn the drive
4
5
6
e f
7
S6AG5A50
8
9
5-30