Transporting The Printer - Oce CS9160 User Manual

Step 9 : The plastic bars are installed to both right and left side of the carriage.
Step 10 : Remove the scroller.
Step 11 : Unplug and remove all cables.
Step 12 : Release the lock of the caster wheels and transfer the printer.
Notes
•
The casters supplied with the dedicated stand are manufactured for a small transfer on a plain
surface. When moving the printer outdoors, and in places with big step differences, then move
the stand and printer separately. For further details please refer to the Installation guide.
Steps after transfer
Step 1 : Choose a suitable place to install the printer.
Refer to "Installation guide"
Step 2 : Verify that the butterfly bolts fixing the stand with the printer are well fixed.
Step 3 : Connect all cables.
Step 4 : Perform a nozzle check, and verify that there is no clogging in the printer head.
Refer to "Nozzle check"
Step 5 : Perform a head alignment.
Refer to "Adjust print"

3.5.2 Transporting the printer

Be sure to read and understand the safety warnings before handling the printer.
When transporting the printer, it is necessary to pack the printer as it was shipped, using the protective
materials and packing materials to protect the printer from vibration and shocks. In case your printer is
currently loaded with Bio-Lactite or Low Solvent Ultra ink, the printer needs to be in Longstore mode
before transporting.
Please refer to Longstore procedure.
Notes
•
When transporting the printer, consult your OCÉ product representative.
Pre- transport procedure
Step 1 : Switch ON the printer.
Step 2 : Verify that the printer is in Normal mode.
Step 3 : Remove all ink cassettes.
Step 4 : Switch OFF the printer.
Step 5 : Verify that the power light faints when the ink rejection operations has been finished.
Step 6 : Remove the scroller or the optional winding system.
Step 7 : Remove all cables.
User's Guide Océ CS9160 printer
37 AP-40790 – Rev 2.0 -23/08/2011,