Suzuki GRAND VITARA Owner's Manual page 351

7) Remove engine jack.
8) Install front and rear propeller shafts referring to
"Propeller Shaft Removal and Installation: in Section
3D".
9) Install exhaust No.1, No.2 and center pipes referring
to "Exhaust System Components: in Section 1K".
10) Install A/C compressor to its bracket (if equipped)
referring to "Compressor Assembly Removal and
Installation for M16 Engine Model: in Section 7B".
11) Install P/S pump to its bracket (if equipped) referring
to "P/S Pump Removal and Installation for M16
Engine Model: in Section 6C".
12) Return disconnected hoses, cables and electric
wires noting the followings.
• Tighten nuts to specified torque.
Tightening torque
Starting motor terminal nut: 11 N·m (1.1 kgf-m,
8.0 lb-ft)
Generator terminal nut: 7 N·m (0.7 kgf-m, 5.0 lb-
ft)
13) Install P/S pump and A/C compressor (if equipped)
drive belt referring to "P/S Pump and A/C
Compressor (If Equipped) Drive Belt Removal and
Installation for M16 Engine Model: in Section 6C".
14) Adjust P/S pump and A/C compressor (if equipped)
drive belt tension referring to "P/S Pump and A/C
Compressor (If Equipped) Drive Belt Inspection and
Adjustment for M16 Engine Model: in Section 6C".
15) Install air cleaner case (2).
16) Connect MAF sensor connector (1).
2
1
I5JB0A141004-02
Engine Mechanical: For M16A Engine with VVT 1D-17
17) Install air intake pipe (2).
18) Connect breather union (1) to air intake pipe (2).
1
19) Check all removed parts are back in place.
20) Refill cooling system with coolant referring to
"Cooling System Flush and Refill: in Section 1F".
21) Refill engine with engine oil referring to "Engine Oil
and Filter Change: in Section 0B".
22) Install engine hood after disconnecting windshield
washer hose.
23) After installation, bleed air from clutch system.
Refer to "Air Bleeding of Brake System: in Section
4A" for air bleeding procedure.
24) Connect negative cable at battery.
25) With engine OFF, turn ignition switch to ON position
and check for fuel leakage.
26) Start engine and check coolant oil and exhaust gas
leakage at each connection.
2
I5JB0A141008-03