Suzuki GRAND VITARA Owner's Manual page 384

1D-50 Engine Mechanical: For M16A Engine with VVT
Selection of Connecting Rod Bearings
NOTE
• If bearing is in malcondition, or bearing
clearance is out of specification, select a
new standard bearing according to the
following procedure and install it.
• When replacing crankshaft or connecting
rod and its bearing due to any reason,
select new standard bearings to be
installed by referring to numbers stamped
on connecting rod and its cap and/or
alphabets stamped on crank web of No.3
cylinder.
1) Check stamped numbers on connecting rod and its
cap as shown.
Three kinds of numbers ("1", "2" and "3") represent
the following connecting rod big end inside
diameters.
For example, stamped number "1" indicates that
corresponding connecting rod big end inside
diameter is 45.000 – 45.006 mm (1.7717 – 1.7718
in.).
Connecting rod big end inside diameter
Stamped
Connecting rod big end inside diameter
numbers
1 45.0000 – 45.0060 mm (1.7717 – 1.7718 in.)
2 45.0061 – 45.0120 mm (1.7719 – 1.7721 in.)
3 45.0121 – 45.0180 mm (1.7722 – 1.7723 in.)
[A]: Connecting rod big end inside diameter number
[B]: Weight indication mark
2) Next, check crankshaft pin diameter. On crank web
No.3, four alphabets are stamped as shown in the
figure.
Three kinds of alphabet ("A", "B" and "C") represent
the following crankshaft pin diameter respectively.
For example, stamped "A" indicates that
corresponding crankshaft pin diameter is 41.994 –
42.000 mm (1.6533 – 1.6534 in.).
Crankshaft pin outer diameter
Stamped
alphabet
A
B
C
I3RH0A140017-01
Crankshaft pin diameter
41.9940 – 42.0000 mm (1.6533 – 1.6534 in.)
41.9880 – 41.9939 mm (1.6531 – 1.6532 in.)
41.9820 – 41.9879 mm (1.6529 – 1.6530 in.)
[A]: Crankshaft pin diameter for No.1 cylinder
[B]: Crankshaft pin diameter for No.2 cylinder
[C]: Crankshaft pin diameter for No.3 cylinder
[D]: Crankshaft pin diameter for No.4 cylinder
I3RH0A140018-01