Electric Throttle Body Assembly On-Vehicle Inspection - Suzuki GRAND VITARA Owner's Manual

4. Voltmeter
4) Install MAP sensor securely.
5) Connect MAP sensor connector securely.
Electric Throttle Body Assembly On-Vehicle
Inspection
WARNING
!
Never touch throttle valve with finger while
ignition switch is turned ON and accelerator
pedal is depressed. Otherwise, injury may
result by pinching the finger between throttle
valve and throttle body housing.
CAUTION
!
• Do not disassemble electric throttle body
assembly.
• Do not expose electric throttle body
assembly to excessive shock like a
dropping it. If electric throttle body
assembly has been exposed to excessive
shock, it should be replaced.
• Be careful not to accrete a foreign material
(like dust and/or metallic particle) to the
throttle body housing and/or throttle valve.
Otherwise, the throttle body assembly is
breaking down by throttle valve accretion.
• Do not apply excessive moving force to
throttle valve for throttle valve operation
check and/or TP sensor performance
check.
Otherwise, the throttle body assembly is
breaking down by damaging the internal
resinous gear of throttle valve actuator.
Throttle Valve Visual Check
1) Remove air cleaner outlet hose (for J20 engine) or
air intake pipe (for M16 engine).
2) Check that there isn't any foreign matter caught
between throttle valve and throttle body housing. If
there is, take it out after removing throttle body
referring to "Electric Throttle Body Assembly
Removal and Installation: For J20 Engine in Section
1D" or "Electric Throttle Body Assembly Removal
and Installation: For M16A Engine with VVT in
Section 1D"and clean inside of throttle body
thoroughly.
Throttle Valve Operation Check
I3RM0A130005-01
1) Remove air cleaner outlet hose (for J20 engine) or
air intake pipe (for M16 engine).
2) Turn OFF ignition switch.
3) Move throttle valve with finger to its full open position
and check that it moves smoothly.
4) Move throttle valve with finger to its completely
closed position and check that it moves smoothly.
S5JB0A1306022
5) Take off finger from throttle valve (1) which is at full
open position and check that it moves smoothly by
its return spring and open spring force back to
default position (position where throttle valve is open
by 7° (2) from completely closed position).
6) Take off finger from throttle valve (1) which is at
completely closed position and check that it moves
smoothly by its return spring and open spring force
back to default position.
If check result is not satisfactory, replace electric
throttle body assembly.
Engine Electrical Devices:
1
2
1C-2
I5JB0A130013-01
I5JB0A130035-01