Suzuki GRAND VITARA Owner's Manual page 416

1D-82 Engine Mechanical: For J20 Engine
12) For M/T model, remove shift control lever referring to
"Transmission Shift Control Lever Removal and
Installation: in Section 5B".
13) Remove exhaust No.1, No.2 and center pipes
referring to "Exhaust System Components: in
Section 1K".
14) Remove front and rear propeller shafts referring to
"Propeller Shaft Removal and Installation: in Section
3D".
15) With hose connected, detach P/S pump from its
bracket (if equipped) referring to "P/S Pump
Removal and Installation for J20 Engine Model: in
Section 6C".
CAUTION
!
Suspend removed P/S pump at a place where
no damage will be caused during removal
and installation of engine assembly.
16) With hose connected, detach A/C compressor from
its bracket (if equipped) referring to "Compressor
Assembly Removal and Installation for J20 Engine
Model: in Section 7B".
CAUTION
!
Suspend removed A/C compressor at a place
where no damage will be caused during
removal and installation of engine assembly.
17) Support front suspension frame and engine rear
mounting member using jack (2).
18) Carry out Step 1) to 12) of "Removal" under "Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation: in Section 2B" in order to
lower engine with front suspension frame.
19) Remove front suspension frame mounting bolts (1).
1
20) Remove engine rear mounting member bolts (1).
21) Before lowering engine, recheck to make sure all
hoses, electric wires and cables are disconnected
from engine.
22) Lower engine with transmission, transfer, front
suspension frame and engine rear mounting
member from engine compartment.
!
Before lowering engine, in order to avoid
damage to A/C compressor and P/S pump,
make clearance by rising them.
23) Disconnect transmission from engine referring to
"Manual Transmission Assembly Dismounting and
Remounting: in Section 5B" or "Automatic
Transmission Unit Components: in Section 5A", if
necessary.
24) Remove engine with engine front mounting bracket
(1) from engine front mounting (2), if necessary.
25) Remove clutch cover and clutch disk referring to
2
I5JB0A142018-01 "Clutch Cover, Clutch Disc and Flywheel Removal
and Installation: in Section 5C", if necessary.
1
CAUTION
1
2
1
I5JB0A142019-01
1
2
I5JB0A142020-01