Suzuki GRAND VITARA Owner's Manual page 320

1C-3 Engine Electrical Devices:
Electric Throttle Body Assembly Operation Check
1) Remove air cleaner outlet hose (for J20 engine) or
air intake pipe (for M16 engine).
2) Turn ON ignition switch.
3) Depress accelerator pedal gradually and check that
throttle valve moves smoothly until it opens fully.
4) Release accelerator pedal depressed in Step 3) and
check that throttle valve (1) moves back to default
position (position where throttle valve is open by 7°
(2) from its completely closed position).
2
If check result is satisfactory, electric throttle body
system is in good condition. If check result is not
satisfactory, proceed to next step.
5) Perform "Accelerator Pedal Position (APP) Sensor
Assembly On-Vehicle Inspection", "Throttle Actuator
(Motor) Check" and "Throttle Position Sensor
Performance Check".
If check results are not satisfactory, replace electric
throttle body assembly.
If check results are satisfactory, wire circuit and/or
ECM are faulty.
Throttle Actuator (Motor) Check
1) Turn OFF ignition switch.
2) Disconnect connector from electric throttle body
assembly.
3) Measure resistance between "M1" terminal (1) and
"M2" terminal (2) of electric throttle body assembly.
If measured resistance is out of specified value,
replace electric throttle body assembly.
Throttle actuator (motor) resistance
0.3 – 100 Ω at 20 °C, 68 °F
[A]
1
[A]: For J20 engine
[B]: For M16 engine
1
I5JB0A130035-01
[B]
2 2 1
I5JB0A130014-01
Throttle Position Sensor Performance Check
1) Remove air cleaner outlet hose (for J20 engine) or
air intake pipe (for M16 engine).
2) Turn OFF ignition switch.
3) Disconnect connector from electric throttle body
assembly.
4) Check throttle position sensor (main and sub) output
voltage as following steps.
a) For throttle position sensor (main), arrange 3
new 1.5 V batteries (1) in series (check that total
voltage is 4.5 – 5.0 V) and connect its positive
terminal to "Vin" terminal (2) and negative
terminal to "Ground" terminal (3) of sensor. Then
using voltmeter, connect positive terminal to
"Vout 1" terminal (4) of sensor and negative
terminal to battery.
[A] 4
[B]
3
[A]: For J20 engine
[B]: For M16 engine
b) For throttle position sensor (sub), arrange 3 new
1.5 V batteries (1) in series (check that total
voltage is 4.5 – 5.0 V) and connect its positive
terminal to "Vin" terminal (2) and negative
terminal to "Ground" terminal (3) of sensor. Then
using voltmeter, connect positive terminal to
"Vout 2" terminal (4) of sensor and negative
terminal to battery.
2 3
1
2 4
1
I5JB0A130015-01