Replacing The Inlet Assembly, Inlet Board Assembly And Lever Foot Sw Cable Assembly - MUTOH Falcon II Outdoor Maintenance Manual

4.4.3. Replacing the inlet assembly, inlet board assembly and lever foot SW cable
assembly
Step 1 :
Follow the instructions in "Replacing the Mainboard assembly, HDD_Extension board assembly, HEAD_DRV
board assembly, PCI_Linux board assembly and cooling fan assembly" to remove the Mainboard assembly.
Step 2 :
Follow step 2 to 4 in "Replacing the power source board assembly" to remove the Mainboard assembly.
Step 3 :
Remove the connector between the inlet board assembly and the inlet assembly.
Step 4 :
Remove the 4 screws fixing the inlet board assembly.
1 = Inlet board assembly
3 = Inlet assembly
5 = Screw (M4x8) fixing the inlet assembly
Step 5 :
Replace the inlet board assembly.
Step 6 :
Remove the 3 screws fixing the inlet assembly.
Step 7 :
Replace the inlet assembly.
Step 8 :
Remove the 3 screws fixing the lever foot SW cable assembly.
Step 9 :
Replace the lever foot SW cable assembly.
Step 10 :
Reinstall all parts in the opposite order of the removal procedure.
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M3x6) fixing the inlet board assembly
4 = Screws (M3x6) fixing the inlet assembly and
lever foot SW cable assembly
6 = Lever foot SW cable assembly
74 AP-74065, Rev. 1.0, 21/11/03