Repeatability Adjustment Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.5.5. Repeatability Adjustment Menu

This menu is used to align the head positions for two-way printing.
To align the head position for two-way printing, you should first print out a Bi-D printing and identify the difference between
the CW printing position and the CCW printing position.
To perform a Bi-directional Adjustment, please follow the steps mentioned below.
Step 1 :
Go to [Adjust : Bi-D].
Step 2 :
Print out the Bi-Directional pattern.
Caution :
For a straight line :
→ In case the reference is on the right side, use the plus (+) value to adjust.
→ In case the reference is on the left side, use the minus (-) value to adjust.
Step 3 :
Adjust the Bi-Directional for every head height.
# 1 : Head height LOW
# 2 : Head height MIDDLE
# 3 : Head height HIGH
Caution :
Due to the tolerance of parts and assembly precision, all lines might not be straight. If
this is the case, adjust the bi-directional difference amount equally.
Falcon II Outdoor series printers – Maintenance Manual
1 = Adjust this dash line so it becomes a straight line.
173 AP-74065, Rev. 1.0, 21/11/03