Back - MUTOH Falcon II Outdoor Maintenance Manual

7 Media cut groove
8 Carriage cover
9 Foot switch
10 Paper Guide

2.3.2. Back

No.
1 AC inlet
2 Interface connector
3 Foot switch connector
4 Insertion slot
5 Interface slot 1
6 Interface slot 2
7 Interface slot 3
8 Hard disk slot
9 Nameplate rating
10 Rear Heater
Only onto the Falcon II Outdoor 4H printer !
Used to cut the media straight when it is cut manually.
Only onto the Falcon II Outdoor printer !
This is a cover to protect the user from the internal components of the
unit. This is opened during following operation :
When cleaning the cleaning wiper
This switch is used to raise and lower the pressure rollers.
Support the media during printing
In the Falcon II Outdoor it houses post-heater (dryer).
In the Falcon II Outdoor 4H it houses the fixer, post-fixer and dryer.
Name
This is the inlet interface to which the power plug is connected.
This is the connector to which the interface cable is connected.
This is the connector to which the foot switch cable is attached.
This is the slot for inserting media when loading it.
The network interface board attaches here.
This is not used for this printer.
Close it with the cover.
The hard disk attaches here. When not using a hard disk, keep the
cover closed.
The type, name, serial number, rating and other details of the printer are
labelled here.
Supports the media during printing and houses the pre-heaters.
Falcon II Outdoor series printers – Maintenance Manual
19
Function
AP-74065, Rev. 1.0, 21/11/03