Replacing The H Ink Tube, Tube Branch And Damper Assembly - MUTOH Falcon II Outdoor Maintenance Manual

4.7.3. Replacing the H ink tube, tube branch and damper assembly

Notes :
Step 1 :
Drain the ink from all ink paths according to "Head wash menu".
Step 2 :
Follow step 1 in "Replacing the print head assembly and head tape power cable" to remove the damper clamp.
Step 3 :
Remove the ink tube and tube branch from the branch fixing material.
1 = Branch fixing material
3 = Ink tube
5 = Coupling screw, O-ring
Step 4 :
Remove the coupling screw and O-ring on the ink tube and the H ink tube sides from the tube branch.
Step 5 :
Replace the tube branch.
Remove following covers before replacing the H ink tube, tube branch, and damper
assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Head cover: refer to "Removing the head cover"
Falcon II Outdoor series printers – Maintenance Manual
2 = Tube branch
4 = H ink tube
110 AP-74065, Rev. 1.0, 21/11/03