7.5. STEEL BELT TENSION ADJUSTMENT
The procedure for adjusting the steel belt tension is explained below.
This section explains the procedure for adjusting steel belt tension. When removing/installing the steel belt, adjust its
tension.
7.5.1. Tools required for work
The following tools are required when adjusting the tension of the steel belt.
Tension gauge: max. 2.0 N (200 g)
Steel belt tension attachment 2: for gauge diameter 2mm (0.08in.) or less
Notes :
Refer to "jig and Tool list".
7.5.2. Adjustment Procedure
Use the following procedure to adjust the tension of the steel belt.
Step 1 :
Place the tension gauge at the center of the steel belt.
1 = steel belt
Notes :
The regulation values for the tension of the steel belt are shown below.
Falcon II Outdoor series printers – Maintenance Manual
2 = Tension gauge
50 inch, 64 inch specifications: 1.0 N ± 0.1 N (100 g ± 10 g)
87 inch specifications: 0.9 N ± 0 .1 N (90 g ± 10 g)
236
AP-74065, Rev. 1.0, 21/11/03