Endurance Running Check Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.9.10. Endurance Running Check Menu

In this menu, you can confirm the number of endurance running cycles that have been already finished.
The number of endurance running cycles is stored in NVRAM in the system. Therefore, even if a serious error occurs
during endurance running, you can confirm the number of finished cycles just before the occurrence of the serious error.
* Check *
CR Motor
PF Motor
* Check *
Cutter
Head U/D
* Check *
Head lock
Wiper
* Check *
Pump
Lever Motor
* Check *
Nozzle
Total Life
Falcon II Outdoor series printers – Maintenance Manual
50 Number of endurance running cycles (CR Motor)
0 Number of endurance running cycles (PF Motor)
(1/5)
33 Number of endurance running cycles (Cutter)
55 Number of endurance running cycles (Head
(2/5) up/down)
77 Number of endurance running cycles (head lock)
77 Number of endurance running cycles (wiper)
(3/5)
77 Number of endurance running cycles (pump mot)
77 Number of endurance running cycles (sequential
(4/5) Printing)
77
88 Number of endurance running cycles (All)
(5/5)
210 AP-74065, Rev. 1.0, 21/11/03