Adjustment - MUTOH Falcon II Outdoor Maintenance Manual

7.2. ADJUSTMENT

The adjustments required when replacing parts are explained below.
When adjusting or replacing maintenance parts shown in the table below, a printing adjustment is required using the auto-
diagnostic function on the printer. Refer to the table below while making adjustments.
Replaced or Adjustment
adjusted part order
Print head
Mainboard
assembly
1 Head rank input (including initial filling)
2 Head nozzle check
3 Head angle check
4 Head precision adjustment
5 Repeatability adjustment
6 CW adjustment
7 Test Print
8 Head unit lifespan count reset
1 Parameter backup
2 Firmware installation
3 Machine size select
4 Backup parameter installation
5 Media sensor sensitivity adjustment
6 Head rank input
7 Head nozzle check
8 Head angle check
9 Repeatability adjustment
10 CW adjustment
225
Falcon II Outdoor series printers – Maintenance Manual
Adjustment Refer to
→ Head rank input menu
→ Head Nozzle Check
Menu
→ Head Slant Check
Menu
→ Head precision
adjustment
→ Repeatability
Adjustment Menu
→ CW Adjustment Menu
→ Test print menu
→ Parameter
Initialization Menu
→ Parameter backup
→ Firmware installation
→ Machine size select
menu
→ Backup parameter
installation procedure
→ Media sensor
sensitivity adjustment
→ Head rank input menu
→ Head Nozzle Check
Menu
→ Head Slant Check
Menu
→ Repeatability
Adjustment Menu
→ CW Adjustment Menu
AP-74065, Rev. 1.0, 21/11/03