Step 4 :
Follow the instructions in "Parameter Update Menu" and refer to the printed adjustment variable to enter
following setting value.
Head voltage
Printing position alignment (Bi-D)
CW adjustment
Media feed distance
Mechanical parameter (Top margin, Bottom margin, Side margin, P_REAR sensor position)
Ink parameter (Initial ink charge flag)
Ink ID mask
Serial number
Notes :
Maintenance history cannot be input.
7.4. FIRMWARE INSTALLATION
The procedure for installing firmware is explained below.
The programs (firmware) that control the operation of the printer are recorded on the NVRAM (Flash-ROM) installed on the
Mainboard.
Install firmware when performing the following maintenance operations.
When replacing the Mainboard assembly
When upgrading firmware
Notes :
When PC is used, the firmware cannot be installed via PCI_Linux board. Install via
Centronics.
Caution :
Before installing firmware, be sure that the power to the printer is turned off.
Performing these operations with the power on could result in damage to the Mainboard
assembly or cause the data to not be installed correctly.
Falcon II Outdoor series printers – Maintenance Manual
231
AP-74065, Rev. 1.0, 21/11/03