Table of Contents
Advertisement
6.3.3. MAC address write enable menu
It could happen that the computer cannot make connection with the Falcon II Outdoor printer. If this is the case, the MAC
address of the Falcon II Outdoor printer has probably been set to zero or incorrect.
To insert the MAC address into the Falcon II Outdoor printer, please follow the instructions mentioned below.
Notes :
6.3.3.1. Request correct MAC address
Step 1 :
Remove the Right Cover.
Step 2 :
Remove the Ethernet Board Cover.
Step 3 :
Onto the installed card you can see a sticker with a 'FM0 number'.
Notes :
Write down this number 'FM0 xxxxxx'. Important are the 6 digits 'x'.
Step 4 :
Based on this number Mutoh Europe's service department can provide you the correct MAC address for your
printer.
Step 5 :
Reinstall the covers.
6.3.3.2. Insert the MAC address into the printer
Step 1 :
Power on the unit in a special mode. Press the [POWER] key to power ON the unit, while simultaneously
holding the [F1], [F3] and [Menu ↑] key.
Step 2 :
The unit will start up in special mode. Following message will appear on the display.
F3 →
For the MAC address, a unique number is assigned for each unit. Do not use this
function except when intending to recover following deletion of the MAC address.
Please note that this procedure is only available onto the Falcon II Outdoor printers
with following firmware version or higher.
Falcon II Outdoor : V2.00
* Counter *
Indication
MACaddress
Falcon II Outdoor series printers – Maintenance Manual
InitMenu
222
AP-74065, Rev. 1.0, 21/11/03
Advertisement
Table of Contents
Troubleshooting
