Replacing The Cr Actuator; Replacing The Cr Motor Assembly - MUTOH Falcon II Outdoor Maintenance Manual

4.6. REPLACING THE CR ACTUATOR

4.6.1. Replacing the CR motor assembly

Caution :
The motor is hot after the product has been operated, so be careful not to burn yourself.
Notes :
Step 1 :
Remove the CR motor cable assembly connector from the CR motor assembly.
Step 2 :
Remove the 4 hexagon socket head cap screws fixing the CR motor assembly.
Step 3 :
Replace the CR motor assembly.
1 = CR motor assembly
3 = Hexagon socket head cap screws (M3x6)
Step 4 :
Reinstall all parts in the opposite order of the removal procedure.
Step 5 :
Adjust the tension of the CR deceleration belt according to "CR deceleration belt tension adjustment".
Remove following covers before replacing the CR motor assembly.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Media guide F: refer to "Removing media guide F"
Falcon II Outdoor series printers – Maintenance Manual
2 = Connector
90 AP-74065, Rev. 1.0, 21/11/03