Head Up/Down Endurance Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.9.4. Head Up/Down Endurance Menu

This menu performs endurance running for the head up/down operation.
You can perform the capping operation according to your desired settings. The available settings are shown below.
Setup item
Waiting time
Number of endurance
running cycles
Notes :
* LifeCount *
Count
* Head U/D *
Time Wait (sec)
* Head U/D *
Count
* Head U/D *
End
Description
Set the waiting time after
one cycle of endurance
running
Set the number of
endurance running
cycles
If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
The waiting time is not modifiable.
-1 → 10000 +
↓ ENTER
↓ ENTER or CANCEL
↓ ENTER or CANCEL
Falcon II Outdoor series printers – Maintenance Manual
Parameters
10
-1 to 10000
Number of endurance running cycles
50 -
10 Check wait time
5 Perform endurance running
50
202
Remarks
Unit: second
AP-74065, Rev. 1.0, 21/11/03