Replacing The Slide Motor Assembly, Hd_Slide Sensor Assembly, And Slide Motor Installation Board - MUTOH Falcon II Outdoor Maintenance Manual

4.6.3. Replacing the SLIDE motor assembly, HD_SLIDE sensor assembly, and
slide motor installation board
Caution :
The motor is hot after the product has been operated, so be careful not to burn yourself.
Notes :
Step 1 :
Remove the connectors on the SLIDE motor assembly and HD_SLIDE sensor assembly.
Step 2 :
Remove the 2 screws fixing the SLIDE motor assembly.
1 = SLIDE motor assembly
3 = HD_SLIDE sensor assembly
5 = Slide motor installation board
Step 3 :
Replace the SLIDE motor assembly.
Step 4 :
Remove the 2 screws fixing the HD_SLIDE sensor assembly.
Step 5 :
Replace the HD_SLIDE sensor assembly.
Step 6 :
Remove the 2 screws fixing the slide motor installation board.
Remove following covers before replacing the SLIDE motor assembly, HD_SLIDE
sensor assembly, and slide motor installation board.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
Falcon II Outdoor series printers – Maintenance Manual
2 = Screws (M3x6) fixing the SLIDE motor assembly
4 = Screws (M2x8) fixing the HD_SLIDE sensor
assembly
6 = Screws (M4x6) fixing the slide motor installation
board
93 AP-74065, Rev. 1.0, 21/11/03