Parts Replacement; Introduction - MUTOH Falcon II Outdoor Maintenance Manual

4.1. INTRODUCTION

This chapter explains the procedures for replacing and removing maintenance parts.
Important :
Before replacing parts, be sure to perform following operations.
Turn the power OFF.
Remove the electrical cable from the socket. Otherwise, you may
suffer electric shock or the machine's electric circuits may be
damaged.
Disconnect all cables from the machine. Not doing so could cause
damage to the printer.
Caution :
Assembling and disassembling the printer are possible only for the parts for which
disassembling procedures are shown in the operation manual.
Do not disassemble any frame parts or parts for which disassembling procedures are
not shown in the manual.
Doing so may cause trouble that cannot be restored, as the printer is originally
assembled in the factory with a high accuracy of 1/100 mm.
Notes :
After replacing the parts, perform necessary lubrication/bonding according to
"Lubrication/Bonding".
32
Falcon II Outdoor series printers – Maintenance Manual

4. PARTS REPLACEMENT

AP-74065, Rev. 1.0, 21/11/03