Replacing The Transmission Photosensor (Wiper Home Position And Maintenance Home Position) - MUTOH Falcon II Outdoor Maintenance Manual

4.8.4. Replacing the transmission photosensor (wiper home position and
maintenance home position)
Step 1 :
Remove the transmission photosensor from the side plate R.
1 = Transmission photosensor (wiper origin side)
3 = Wiper origin cable assembly
5 = Side plate R
Step 2 :
Remove each origin cable assembly from the transmission photosensor.
Step 3 :
Remove the transmission photosensor.
Step 4 :
Apply the screw lock to the tab portions of the transmission photosensors to be installed.
Step 5 :
Reinstall all parts in the opposite order of the removal procedure.
Notes :
When installing the origin cable assembly onto the transmission photosensor, be
careful to not confuse the connectors.
Wiper origin cable assembly (black): front
Maintenance origin cable assembly (white): rear
Falcon II Outdoor series printers – Maintenance Manual
2 = Transmission photosensor (maintenance origin
side)
4 = Maintenance origin cable assembly
128 AP-74065, Rev. 1.0, 21/11/03