Head Slant Check Menu - MUTOH Falcon II Outdoor Maintenance Manual

5.5.4. Head Slant Check Menu

This menu prints out a sample printing to check for head slant.
Item
Slant
Front and back
All
end
5.5.4.1. Slant
To perform a Head Slant Adjustment, please follow the steps mentioned below.
Step 1 :
Go to [Adjust : Head Slant].
Step 2 :
Print out [SLANT] pattern two times.
Step 3 :
Remove the Damper Press.
Step 4 :
Loosen the screw which secures the Head Fixing Plate.
1 = Head Fixing Plate securing screw
2 = Slant Adjust Screw
Step 5 :
Adjust the Head Slant by moving the Head Slant Adjust Screw.
Caution :
Please adjust so each pattern edge is a straight line.
In case CW is aligned and CCW might not be aligned, adjust them as the deviation
amount of CW and CCW should be the same. This gives less difference of the Bi-
directional print.
In case you plan to use the printer as proofer, only adjust CW.
Description
All head slant check.
Front and back position and slant of each head relative to the reference head check.
Confirmation of the forward and rear positions for all nozzle rows and all heads.
Check complete.
Falcon II Outdoor series printers – Maintenance Manual
169 AP-74065, Rev. 1.0, 21/11/03