Problems Relating To The Paper Cutting Operation - MUTOH Falcon II Outdoor Maintenance Manual

9.3.5. Problems relating to the paper cutting operation

No. Phenomenon
1 The cutting operation is not
performing correctly.
Falcon II Outdoor series printers – Maintenance Manual
Check point Action
(1) Check the • Change the
operation panel and setting.
make sure that the
media cutting
setting is not set to
off or manual.
(2) Check the • Change the
operation panel and setting.
make sure that
PaperDet. has not
been set to
TakeUpRoll.
(3) Check the cutter • Remove the
grooves for accumulated paper
accumulated paper dust along the
dust and clips. direction of the
grooves.
(4) Is the cutter cap • Reset the cutter
securely insalled? cap securely.
(5) Check the • If it does not rise :
cutter's up and go to step 4
down sliding • if it rises : go to
operation. step 5
(6) Check if the • If it drops :
cutter drops to the The cutter spring
bottom end under its may have a
own weight when problem. Replace
the cutter is installed the cutter spring
without the cutter while referring to the
spring. unfolded view.
• If it does not drop :
The cutter may have
a problem. Replace
the cutter. If the
cutter does not drop
after it is replaced,
replace the cutter
holder.
(7) Check the up
and down operation
of the solenoid via
"Life/Cutter" of the
self-diagnostic
function.
326
Refer to
→ User's Guide
→ User's Guide
→ User's Guide
→ User's Guide
-
→ Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
AP-74065, Rev. 1.0, 21/11/03