Assembly And Setup Of The Board Printer; Identifying The Tables And Spacer Fins - MUTOH toucan lt Setup & Operating Instruction

Setup instructions for Toucan LT board printer

Assembly and Setup of the Board printer:

During the 'ink fill' unpack the 'tables' from their shipping box.
Notice that on the front and rear of the Toucan LT Board printer there are two large
brackets on which there is a large stainless 'mounting' pin on each one. This pin will
screw up and down as required in a later step.
Mounting 'Pin' on front and back of printer. Mounting 'Pin bracket' on the sides of tables.
The mounting 'pins' are the main support on the right and left sides of each table where
there is a corresponding 'mounting pin support bracket' on each side of the table.
Notice that the bracket in front of the 'ink pump' station must be removed to verify
'ink flow' during the wash and ink fill processes. A 3mm Allen wrench is required to
remove the bracket.

Identifying the tables and spacer fins:

Tables:
The 'rear' table (at right) is identified by the
absence of screws along the 'inside' edge of
the table. The 'outside' edge is a 'finished'
edge while the 'inside' edge (the edge
closest to the printer) is smooth aluminum.
February 21, 2006
The 'front' table (at left) is identified by a row
of screws, each with a rubber spacer, along the
smooth aluminum edge.
2/12 Toucan LT board printer setup